PROTEINI.SI vinyl decal:
Dimensions: 18.5 cm x 5.5 cm
Easy to apply
Suitable for applying on smooth surfaces (glass, metal, plastic, ...)
Both for external and internal use
Resistant to all weather conditions
DECAL INSTALLATION GUIDE:
Prepare the surface
The lowest application temperature for adhesion on flat or slightly curved surfaces is 10°C. Make sure that the application surface is clean and completely dry before installation.
Prepare the decal
Once the surface is clean, lay the decal on a hard surface like a table and rub the top layer of transfer tape back down on the design. This will make sure that the transfer tape is fully adhering to the vinyl (PROTEINI.SI inscription).
Peel the hard paper backing off
Slowly and carefully peel the hard paper backing away from the transfer and decal. The decal should be left sticking to the transfer tape. If it still sticks to the hard paper backing, firmly press the transfer tape and hard paper backing back together and repeat repeat the process until the decal sticks to the transfer tape. Once the hard paper back is peeled off, make sure the transfer tape doesn't fold over and stick to itself (if it sticks to itself, the decal will be ruined).
Apply to the application surface
Place the transfer tape carefully on the desired location and rub immediately over the entire transfer tape surface. When the transfer tape is fully and well attached on the surface, peel it back from the surface. Again, remove it slowly and carefully and watch that the decal is no longer attached to the transfer tape. Choose a corner to start from and and pull at a parallel angle to the surface. If you notice any air bubbles, use a pin and poke a tiny hole. Then squeeze the air bubble out by using your thumb or squeegee.